Harbor-freight-tools CHICAGO 46507 Manuel d'utilisateur

7” POLISHER/SANDERModel 46507ASSEMBLY ANDOPERATING INFORMATION3491 Mission Oaks Blvd., Camarillo, CA 93011Visit our Web site at http://www.harborfreig

SKU 46507 PAGE 10parts and any other condition that may affect its safe operation. If abnormalnoise or vibration occurs, turn off the Polisher/Sander

SKU 46507 PAGE 11PARTS LIST1AdaptorRubber Backing PlateWool CompoundingBonnetREV 09/02

PARTS LISTNOTE: Some parts are listed and shown for illustration purposes only, and are notavailable individually as replacement parts.SKU 46507 PAGE

SPECIFICATIONS TABLESAVE THIS MANUALYou will need this manual for the safety warnings and precautions, assembly,operating, inspection, maintenance, an

6. DRESS SAFELY. Non-skid footwear or safety shoes should be used whenworking with this product. Do not wear loose clothing or jewelry as they canbe

3. IF YOU USE AN EXTENSION CORD, MAKE SURE TO USE ONLY ULAPPROVED CORDS HAVING THE CORRECT GAUGE AND LENGTH.(SEE FIGURE A.)REQUIRED EXTENSION CORD GAU

11. MAKE SURE THE WORKPIECE IS SUPPORTED AT ALL TIMES DURINGOPERATION. Use a Roller Stand (not provided) with larger workpieces ifnecessary.12. MAINT

ASSEMBLY INSTRUCTIONSNOTE: For additional references to the parts listed below, refer to the AssemblyDiagram on page 11 of this manual.To Attach The

To Attach The Side Handle:1. NOTE: The Side Handle (part #20) may be attached either on the right, left, ortop side of the Polisher/Sander. (See Fig

SKU 46507 PAGE 7To Attach The Rubber Backing Plate And Sandpaper:1. Caution: Prior to installing the Rubber Backing Plate (part #46), make sure thePo

SKU 46507 PAGE 91. Caution: Check to make sure the Switch (part #33) is in its “OFF” position beforeplugging the Power Cord (part #36) into a 110-120