Harbor Freight Tools 9 Hot Laminator Manuel télécharger pdf (Page 6)

3. Your tool must be plugged into an appropriate outlet, properly installed and

grounded in accordance with all codes and ordinances. The plug and outlet

should look like that in the following illustration. (See Figure A.)

3-PRONG PLUG

110 VOLT, GROUNDED,

ELECTRICAL OUTLET

FIGURE A

EXTENSION CORDS

1. Grounded tools require a three wire extension cord.

2. As the distance from the supply outlet increases, you must use a heavier gauge

extension cord. Using extension cords with inadequately sized wire causes a

serious drop in voltage, resulting in loss of power and possible tool damage.

(See Figure B.)

3. The smaller the gauge number of the wire, the greater the capacity of the cord.

For example, a 14 gauge cord can carry a higher current than a 16 gauge cord.

(See Figure B.)

SKU 92499 For technical questions, please call 1-800-444-3353 PAGE 6

FIGURE B

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Harbor Freight Tools 9 Hot Laminator Manuel Page 6