Harbor Freight Tools 14 in. x 40 in. Lathe with 7 in. Sander Manuel télécharger pdf (Page 13)

Page 13SKU 67690 For technical questions, please call 1-800-444-3353.

To Adjust The Tail Stock:

1. Use the Spanner to loosen the Lock

Screw (19) under the Tail Stock (24).

Then slide Tail Stock to the desired

position. See Figure 11, below.

2. Use Spanner to tighten Lock Screw,

securing Tail Stock in place.

To Adjust The Tool Rest:

1. Use the Spanner to loosen the Lock

Screw (19) under Tool Rest Holder

(20). Slide Tool Rest Holder to desired

position. See Figure 12, below.

2. Use Spanner to tighten Lock Screw,

securing Tool Rest Holder in place.

4. Move the Drive Belt to the proper

grooves on the Drive Pulley (10) and

Motor Pulley (12). Make sure that

1/2” of Drive Belt deection is mea-

sured, as shown in Figure 9 below.

FIGURE 9

DRIVE

PULLEY

(10)

MOTOR

PULLEY

(12)

1/2”

DEFLECTION

DRIVE

BELT

(11)

Replace the Belt Cover, snap the

latch on, and use the Screws to se-

cure the Cover back into place.

6. Refer to the Recommended Turning

Speeds Chart below during use. See

Figure 10.

FIGURE 10

Recommended Turning Speeds

Max Work

Diameter In Inches

Speeds (RPM)

2” 2200~3200

3” 1600~2200

4” 1100~1600

5” 750~1100

6”+ 750

Note: The above speeds can vary with different

types of wood and the skill of the operator.

Sanding: Use the fastest speed possible without

burning the wood.

Polishing and Finishing: Typically, polishing and

nishing can be done at faster speeds than turning.

Figure 11

Tail Stock

(24)

Lock

Screw (19)

Tool Rest

Holder (20)

Figure 12

Lock

Screw (19)

Tool Rest

(21)

Tool Rest

Lock Knob

(23)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Commentaires sur ces manuels

Pas de commentaire

Harbor Freight Tools 14 in. x 40 in. Lathe with 7 in. Sander Manuel Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Tours Harbor Freight Tools 14 in. x 40 in. Lathe with 7 in. Sander