Page 13For technical questions, please call 1-800-444-3353.Item 68018
SAFETYOPERATIONMAINTENANCE SETUP
Loading the Tool
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION, BEFORE LOADING:
•
Wear ANSI-approved safety goggles with side shields.
Other people in the work area must also wear ANSI-approved impact safety goggles with side shields.
•Release the trigger.
•Detach the air supply.
•Attempt to fire the Tool into a piece of scrap wood to ensure that it
is disconnected and is incapable of firing any fasteners.
1. Insert the Fasteners into the opening in
the Rear Cover and into the Magazine,
letting the heads of the Fasteners ride in the
Magazine T-Slot until they are past the Stop
(small spring inside Magazine).
2. Pull the Pusher to the rear of the Magazine, and
release it to apply pressure on the Fasteners.
General Operating Instructions
1. Before each use, test the tool as
directed in the prior section.
2. If an automatic oiler is not used, add
a few drops of Pneumatic Tool Oil to the airline
connection before use. Add a few drops
more after each hour of continual use.
WARNING! TO PREVENT
SERIOUS INJURY: Keep second hand
away from tool discharge area,
especially if holding workpiece.
Tool applies extreme force to fastener,
and fasteners may deflect or fire in
an unexpected direction.
CAUTION! TO PREVENT INJURY: Do not hold tool
near body while firing. Tool recoil can cause injury.
3. Attach the Stapler to the air supply at the Air Inlet
Plug. Start your compressor and check the pressure,
making sure it is set at the recommended 60-120
PSI and not to go over the maximum 120 PSI.
4. To fire, open the shut-off valve, place the Safety
against the workpiece. The Stapler should
not fire if the nose is not depressed. Once
depressed, gently and briefly squeeze the Trigger
once. Do not fire repeatedly. Staples could
bounce off of one another, damaging the
work piece or causing PERSONAL INJURY.
5. Adjust position of the Air Deflector (3) to
direct exhaust away from yourself.
6. Adjust the Depth Adjustment Knob
to control the firing depth.
7. If, at the maximum depth setting, the tool requires
more force to accomplish the task, verify that the tool
receives sufficient, unobstructed airflow (CFM) and
increase the pressure (PSI) output of the regulator
up to the maximum air pressure rating of this tool.
CAUTION! TO PREVENT INJURY
FROM TOOL FAILURE:
Do not exceed the tool’s
maximum air pressure rating.
If the tool still does not have sufficient force
at maximum pressure and sufficient airflow,
then a larger tool may be required.
8. After use, to prevent accidents:
a. Release the trigger.
b. Detach the air supply.
c. Attempt to fire the Tool into a piece of scrap
wood to ensure that it is disconnected
and is incapable of firing any fasteners.
d. Release the trigger again.
e. Clean external surfaces with clean, dry cloth.
f. Store indoors out of children’s reach.
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels