Harbor Freight Tools 98871 Manuel d'utilisateur télécharger pdf (Page 26)

Page 26 For technical questions, please call 1-800-444-3353. SKU 98871

SAFETY SERVICEBASIC WELDING WELDING TIPSSETUP

TROUBLESHOOTING

IMPORTANT!

Be CERTAIN to shut off the Welder, disconnect it from power, and discharge the Gun to ground

before adjusting, cleaning, or repairing the unit.

Wire feed motor runs but wire does not feed properly

POSSIBLE CAUSES AND SOLUTIONS

Insufcient wire feed tension:1.

Increase wire feed tension properly - follow step 16 on page 13.

Incorrect wire feed roll size: 2.

Replace with the proper wire feed roll - follow the  instructions,

starting on page 10.

Flip over wire feed roll if necessary.

Damaged Gun, cable, or liner assembly:3.

Haveaqualiedtechnicianinspectthesepartsandreplaceasnecessary.

Wire creates a bird’s nest during operation

POSSIBLE CAUSES AND SOLUTIONS

Excess wire feed tension:1.

Adjust wire feed tension properly - follow step 16 on page 13.

Incorrect contact tip size: 2.

Replace with the proper tip for the wire.

Gun end not inserted into drive housing properly:3.

Loosen gun securing bolt and push gun end into housing just enough so that it does not

touch wire feed mechanism.

Damaged liner:4.

Haveaqualiedtechnicianinspectandrepair/replaceasnecessary.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33 34

Pas de commentaire

Harbor Freight Tools 98871 Manuel d'utilisateur Page 26