Page 10 For technical questions, please call 1-800-444-3353. Item 60610
SAFETY OPERATION MAINTENANCESETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
Drill Bit Installation
CAUTION! Wear heavy-duty work gloves to provide
protection when inserting and removing drill bits.
Drill bits become very hot during use.
Do not remove drill bits until the bit has cooled.
1. Loosen the Chuck with the Chuck Key until the jaws
of the drill are opened enough to fit the drill bit.
2. Place the desired drill bit into the drill
between the Chuck Jaws.
3. Hand tighten the Chuck until the bit is held securely
in place, centered between the Chuck Jaws.
Insert the tip of the Chuck Key into a hole on the
side of the Chuck so that the teeth on the Key
engage the gear on the Chuck. Use the Key to
tighten the Chuck securely and remove the Key.
NOTICE: Use sharp bits. Dull, bent, or damaged
bits will cause stress on the drill and/or break.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
General Operating Instructions
1. Make sure that the Trigger is in the
off-position, then plug in the tool.
2. Slide the Forward/Reverse Switch
to the forward setting.
CAUTION! Do not change direction while the drill
is operating. Allow chuck to come to a complete
stop prior to changing its direction of rotation.
3. Place the tip of the drill bit on the workpiece.
4. Slowly squeeze the Trigger to start the
tool. Speed is variable depending on
how far in the Trigger is squeezed
5. To lock the Drill on, press and hold the Trigger,
then press the Trigger Lock. Press and
release the Trigger to turn the Drill off.
6. Allow the bit to cut the hole.
7. Remove the bit from the finished hole, then release
the Trigger, or press and release the Trigger if the
Trigger Lock is engaged. Wait for the Drill to come
to a complete stop before laying the tool down.
Note: If a bit becomes wedged into workpiece,
stop and slide the Forward/Reverse Switch to
the reverse setting. Then slowly squeeze the
Trigger to back the bit out of the workpiece.
8. To prevent accidents, turn off the tool and
unplug it after use. Clean, then store the
tool indoors out of children’s reach.
(15 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels