Page 5For technical questions, please call 1-800-444-3353.SKU 66784
Assembly
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION:
Disconnect the Pump from its power
supply before assembly/installation.
Note: For additional information regarding the
parts listed in the following pages, refer to the
Assembly Diagram near the end of this manual.
Note: Pipe thread seal tape mentioned
hereafter is not supplied with this pump.
1. Cut the supplied hose, into two lengths, keeping
in mind that the suction end should be long
enough to reach within one inch of the supply
tank bottom and at the same time to be long
enough so that the Pump could be located at
a point away from the supply tank opening.
NOZZLE
(12)
HOSE
CONNECTOR
(8)
HOSE
CLAMP (10)
HOSE
CLAMP
(10)
HOSE
CONNECTOR
(11)
HOSE
(27)
PUMP
OUTLET
FIGURE A
2. Apply pipe thread seal tape to the threads
of one 3/4″ Hose Connector (8) and
screw it rmly into the Pump outlet.
3. Apply pipe thread seal tape to the threads
of the 1″ Hose Connector (11) and screw
it rmly into the Nozzle (12).
Note: The included Hose (27) can be cut to
provide an inlet and outlet hose, or another hose
of the same size can be purchased as needed.
Any hose used with this product must be
designed for use with the liquid being pumped.
4. Slide two Hose Clamps (10) onto the discharge
Hose (27). Twist each end of the hose over
the two barbed ttings and push forward
until the hose ends presses rmly over the
O-rings and against the tting shoulder.
5. Slide the Hose Clamps to within 3/8″ of
the tting shoulder and tighten the screws,
securing the hose onto the ttings.
6. Apply pipe thread seal tape to the threads
of one 3/4″ Hose Connector (8) and
screw it rmly into the Pump inlet.
FIGURE B
3/4″ HOSE
CONNECTOR
(11)
HOSE (27)
STRAINER
(33)
HOSE
CLAMP (10)
HOSE
CLAMP (10)
PUMP
INLET
7. Slide two Hose Clamps (10) onto the inlet Hose
(27). Twist one end of the hose over the pump
inlet barbed tting and the other end over the
barbed tting on the strainer. Push the hose
forward until the hose ends presses rmly over
the O-rings and against the tting shoulders.
8. Slide the Hose Clamps to within 3/8″ of
the tting shoulder and tighten the screws,
securing the hose onto the ttings.
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels