Page 6 For technical questions, please call 1-800-444-3353. SKU 66784
Operating Instructions
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Inspect pump before use, looking for
damaged, loose, and missing parts.
If any problems are found, do
not use pump until repaired.
Pump Set Up
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION:
Disconnect the Pump from its 12 volt power
source before performing any inspection,
maintenance, or cleaning procedures.
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction or injury.
2. Route the Power Cables (16) along a safe route
to reach the work area without creating a tripping
hazard or exposing the cables to possible damage.
The cables must reach the work area with enough
extra length to allow free movement while working.
3. There must not be hazardous objects, such
as utility lines or foreign objects, nearby that
will present a hazard while working.
4. Have rags nearby to clean up any fuel spills.
5. Have multiple fully charged ABC re
extinguishers nearby in case of re.
General Operating Instructions
1. Connect the Cables with Clamps (16) to a 12 volt
power supply (such as a battery, not included).
Connect the RED Clamp to the Positive (+) terminal
and the BLACK Clamp to the Negative (-) terminal.
2. Insert the Nozzle (12) into the destination tank.
3. Insert the Hose (27) with its Strainer (33) into the fuel
supply tank. Immerse the Strainer in the fuel fully.
4. Press the Power Switch (15) to start the Pump.
5. Squeeze trigger of the Nozzle (12) to
discharge fuel into the destination tank.
Hold the Nozzle rmly during the fuel transfer.
6. To reduce hand fatigue during extended pumping,
lock the Trigger in one of the two positions by lifting
and positioning the spring loaded trigger lock into one
of the two recessed steps under the trigger.
Ease back on trigger to lock it in place.
To stop pumping, pull slightly on the
trigger to release the lock.
7. When the fuel has been transferred,
release pressure on the Nozzle (12) Trigger.
When fuel stops owing, turn off the Pump.
8. Disconnect the Cables with Clamps (16) black
rst, then red, from the 12 volt power supply.
9. Remove the Nozzle from the destination
tank and place in a secure location.
10. Remove the Hose (27) with its Strainer (33)
from the fuel supply tank, allowing fuel to
drain out of the Hose before removing it.
11. Cap both supply and the destination
tanks to prevent fuel spills.
12. Clean and dry all exterior parts of the Pump Body (6),
Hose (27), Nozzle (12), and Cables with Clamps (16).
13. Store the Pump indoors and out of reach of
children and other unauthorized persons.
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels