Harbor Freight Tools 2_1/2 HP 9 in. Benchtop Band Saw Manuel télécharger pdf (Page 11)

Page 11For technical questions, please call 1-800-444-3353.Item 60500

SAFETYOPERATIONMAINTENANCE SETUP

Maintenance and Servicing

Procedures not specifically explained in this manual must

be performed only by a qualified technician.

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:

Turn the Power Switch of the tool off and unplug the tool from its electrical

outlet before performing any procedure in this section.

TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:

Do not use damaged equipment. If abnormal noise or vibration

occurs, have the problem corrected before further use.

Cleaning, Maintenance, and Lubrication

1. BEFORE EACH USE, inspect the general

condition of the tool. Check for:

• blade straightness and teeth sharpness,

• vibration-free operation,

• loose hardware,

• misalignment or binding of moving parts,

• cracked or broken parts,

• damaged electrical wiring, and

• any other condition that may

affect its safe operation.

2. Do not allow saw dust to accumulate

on or in Band Saw.

3. Keep the Wheels clean. Debris on Wheels will

cause poor tracking and possible Blade slippage.

4. Keep mechanisms and sliding surfaces

clean and free of debris.

5. Shielded Ball Bearings do not need lubrication. Small

amounts of lightweight machine oil can be applied

to belt tension mechanisms and sliding surfaces.

6. Paste wax can be applied occasionally to

Table Top (8) to keep it slick and corrosion free.

7. AFTER USE, disconnect from power source, clean

by brushing and wiping with clean, moist cloth.

8. If storing for a long period, release tension on the

Blade by rotating the Blade Release Lever to the

down position. The blade’s tension and tracking

will need to be adjusted after thus storing.

9. WARNING! If the supply cord of this power

tool is damaged, it must be replaced only

by a qualified service technician.

10. Clear all saw dust from Dust Tube (69) at base of

Band Saw. Do not let dust accumulate. Use a shop

vacuum (not provided) attached as a dust collector

when possible, and attach it to the Dust Tube (69).

Occasionally, vacuum out entire Band Saw.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Harbor Freight Tools 2_1/2 HP 9 in. Benchtop Band Saw Manuel Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Harbor Freight Tools 2_1/2 HP 9 in. Benchtop Band Saw