Harbor Freight Tools 16 in. Variable Speed Scroll Saw Manuel télécharger pdf (Page 10)

Page 10 For technical questions, please call 1-888-866-5797. Item 93012

SAFETY OPERATION MAINTENANCESETUP

Maintenance and Servicing

Procedures not specifically explained in this manual must

be performed only by a qualified technician.

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:

Turn the Power Switch of the tool off and unplug the tool from its electrical outlet

before performing any procedure in this section.

TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:

Do not use damaged equipment. If abnormal noise or vibration

occurs, have the problem corrected before further use.

Cleaning and Maintenance

1. BEFORE EACH USE, inspect the general

condition of the tool. Check for:

• loose hardware,

• misalignment or binding of moving parts,

• cracked or broken parts,

• damaged electrical wiring, and

• any other condition that may

affect its safe operation.

2. AFTER USE, wipe external surfaces

of the tool with clean cloth.

3. Periodically, wear ANSI-approved

safety goggles and NIOSH-approved

breathing protection and blow dust out of

the motor vents using dry compressed air.

WARNING! Make sure the power On/Off

Switch (72) of the Scroll Saw is in its “OFF”

position and that the tool is unplugged from its

electrical outlet before performing any inspection,

maintenance, or cleaning procedures. Note: All

repairs should be done by a qualified technician.

4. Before each use, inspect the general condition

of the Scroll Saw. Check for loose screws,

misalignment or binding of moving parts, cracked

or broken parts, damaged electrical wiring,

and any other condition that may affect its safe

operation. If abnormal noise or vibration occurs,

have the problem corrected before further use.

Do not use damaged equipment.

5. Periodically recheck all nuts, bolts,

and screws for tightness.

6. Applying a light coat of paste wax on the Saw

Table allows the material being cut to glide

smoothly across the Saw Table (53) surface. Buff

the wax off with a clean cloth after application.

7. If the Power Cord (2) is worn, cut, or damaged

in any way, replace it immediately.

8. Clean the Scroll Saw by using compressed

air to blow off dirt and dust.

9. Store in a clean and dry location.

10. Over time, if the performance of the Scroll Saw

diminishes, or it stops working completely,

it may be necessary to replace the Carbon

Brushes in the Motor (51) by removing the

Carbon Brush Holder (84) and inspecting the

Carbon Brushes (83). This procedure should

be completed by a qualified technician. If the

Carbon Brushes are not worn down, try cleaning

the Carbon Brush tips with an ink eraser.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Harbor Freight Tools 16 in. Variable Speed Scroll Saw Manuel Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Harbor Freight Tools 16 in. Variable Speed Scroll Saw