Harbor Freight Tools 16 in. Variable Speed Scroll Saw Manuel télécharger pdf (Page 9)

Page 9For technical questions, please call 1-888-866-5797.Item 93012

SAFETYOPERATIONMAINTENANCE SETUP

Inside Cuts

1. Using a pencil, mark the cut-line on the workpiece.

2. Drill a 1/4″ hole in the workpiece.

3. Follow the procedures for removing and installing

the Saw Blade (45) as described on page 13.

4. Place the workpiece on the Saw Table (53) so that

the hole is centered over the Blade access hole.

5. Insert the Blade through the hole in the

workpiece and the Saw Table (53).

6. Reinstall the Blade and properly adjust

tension. Refer to page 13. Make sure Blade

teeth are facing forward and down.

7. While holding the workpiece with one hand, set

the On/Off Switch (72) to the On position.

8. Hold the workpiece with both hands

while guiding and pressing down on the

workpiece until the cut is complete.

9. Set the On/Off Switch to the Off position.

10. Follow the procedures for removing and

installing the Saw Blade (45) as described

in Removing and Installing the Blade.

11. With the Blade removed, the workpiece

can be removed from the Saw Table.

12. Reinstall the Blade and set the proper

tension as described on the next page.

Curved Cuts

1. Mark the entire cutting line with a pencil. If a

template is available, use it as a marking guide.

2. Slide the workpiece underneath the Drop

Foot (48) without touching the Saw Blade (45).

3. Set the On/Off Switch (72) to the On position.

4. Using both hands, carefully guide the workpiece into

the Saw Blade to cut. Press down on the workpiece

and slowly guide it through the Blade. Do not

force the material through the Blade. When cutting

curves, be careful not to twist the Blade out of line.

5. If the curve cut is forced off the cut-line, back the

material off the Saw Blade and start a new, straight

cut through a scrap section of the material. Begin the

curved cut again from an appropriate angle point.

6. Set the On/Off Switch (72) to the Off

position when finished cutting.

Jamming of Saw Blade and Workpiece

1. When the Saw Blade (45) jams in the

workpiece, immediately press the On/Off

Switch (72) to the Off position, and unplug

the Line Cord from the electrical outlet.

2. Wait until the Saw Blade has come to a

complete stop, then remove the Saw Blade

as described in Removing and Installing the

Blade. The workpiece will come with it.

3. Place a flat bladed screwdriver in the cut and

force it open. Remove the Saw Blade.

4. Reinstall the Saw Blade on the machine as

described in Removing and Installing the Blade.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Harbor Freight Tools 16 in. Variable Speed Scroll Saw Manuel Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Harbor Freight Tools 16 in. Variable Speed Scroll Saw