Harbor Freight Tools 16 in. Variable Speed Scroll Saw Manuel télécharger pdf (Page 8)

Page 8 For technical questions, please call 1-888-866-5797. Item 93012

SAFETY OPERATION MAINTENANCESETUP

Operating Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this

manual including all text under subheadings therein before set up or use of this product.

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:

Turn the Power Switch of the tool off and unplug the tool from its electrical outlet

before performing any procedure in this section.

TO PREVENT SERIOUS INJURY:

DO NOT OPERATE WITH ANY GUARD DISABLED, DAMAGED, OR REMOVED.

Moving guards must move freely and close instantly.

Table Angle Adjustment

The Saw Table (53) can be adjusted

between 0 and 45 degrees as follows:

1. Loosen Table Lock Knob (44) and move

the table until the desired angle is reached

as indicated on the Bevel Scale (15).

2. Tighten the Table Lock Knob (44).

Workpiece and Work Area Set Up

1. Designate a work area that is clean and well-lit.

The work area must not allow access by children

or pets to prevent distraction and injury.

2. Route the power cord along a safe route to reach

the work area without creating a tripping hazard or

exposing the power cord to possible damage. The

power cord must reach the work area with enough

extra length to allow free movement while working.

3. There must not be objects, such as utility lines,

nearby that will present a hazard while working.

Turning On and Adjusting Speed

The On/Off locking Switch (72) needs to have the

Switch key inserted before the switch can be used.

This feature prevents unauthorized use of the saw.

1. Insert Switch Key into On/Off Switch (72).

2. To turn saw On, place finger on left

side of switch and push right.

3. To turn saw Off, place finger on right

side of switch and push left.

4. Turn the Variable Speed Knob (81) clockwise

to increase the stokes per minute.

5. To lock switch in Off position, pull out the

Switch key and store in a safe place.

WARNING: Keep hands and fingers

away from the moving Saw Blade.

6. To prevent accidents, turn off the tool and unplug

the tool from its electrical outlet after use. Clean,

then store the tool indoors out of children’s reach.

Straight, Cross, Bevel Cuts, and Ripping

1. Using a pencil, mark the cut-line on the workpiece.

2. Slide the workpiece underneath the Workpiece

Foot (48). If necessary, adjust the Workpiece

Foot by loosening the Workpiece Foot Lock

Knob (68) and sliding the Workpiece Foot (up

or down) until it lightly rests on the workpiece.

Tighten the Workpiece Foot Lock Knob (68).

3. Set the On/Off Switch (72) to the On

position. The Saw Blade starts moving.

4. Using both hands, carefully guide the workpiece

into the blade to cut. Press down on the

workpiece and slowly guide it through the

Saw Blade (45). Do not force the material

through the Blade or the Blade could break.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Harbor Freight Tools 16 in. Variable Speed Scroll Saw Manuel Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Harbor Freight Tools 16 in. Variable Speed Scroll Saw